Handle Removal
If the handle is removed for any reason, always loosen the two Phillips
head screws located on each side of the handle approximately 1/16" each.
This permits the bottom ends of the handle to "toe-in" closer against the
sides of the handle block to fit more closely into the rectangular recess
in the handguard.
Make certain that they are confined within the recess before tightening the
main assembly screw, then finish by re-tightening the handle assembly screws.
It is necessary to use two opposed Phillips Head (No. 2) screwdrivers on
opposite sides of the handles to loosen or tighten the handle assembly screws.
Previous Page
Next Page
Back to the Index